ATS
Air Temperature Sensors - The ATS04 / ATS05 / ATS07 are analogue
sensors with a temperature dependant resistor providing a variable
resistance across the 2 contacts. Signal is negative temperature
coefficient (NTC).
Active
device is a thermistor fitted coated leads in a hermetically sealed
brass / ABS housing.
Data
sheet - ATS Air temperature |
 |
WTS
Fluid Temperature Sensors - The WTS05 / WTS09 are analogue sensors with
a temperature dependant resistor providing a variable resistance across
the 2 contacts. Signal is negative temperature coefficient (NTC).
Active
device is a thermistor fitted coated leads in a hermetically sealed
brass housing.
Data
sheet - WTS Fluid temperature |
|
NTC
Miniature - This miniature 0.2% repeatable thermistor is housed in a
light weight stainless steel body and potted to Mil specifications.
Mounting is via the M6 thread and sealed with a Viton ‘O’ ring.
Suitable
for temperature measurement between -40°c
to + 150°c
Data
sheet - Miniature NTC temperature |
 |
Infra
red tyre temperature sensor - Infra red optical sensor used to
measure tyre surface temperature when the vehicle is moving. Features
include a linear 0-5V output, narrow 14° measuring angle and fully sealed aluminium housing.
Connection
can be made to any analogue measuring circuit via a choice of connector
types.
Data
sheet - Infra red temperature |
  |
Exhaust
temperature thermocouple - Reinforced sheathed type K-Type
thermocouple for exhaust gas temperature on all types of engines.
Features
include a very low response time due to the supported 3.2mm tip,
compensated cable and high temperature cable insulation with stainless
steel braid.
Data
sheet - Exhaust thermocouple |
 |
Type
K Thermocouple - This high quality stainless steel thermocouple
features a high temperature glass reinforced extension cable with a
3.2mm ungrounded hot junction.
Supplied
complete with a resin filled miniature type K connector and spring
strain relief for the cable entry.
Thermocouples
may be measured directly using any of the MM range of TCK capture CAN
modules or by using a standard 0-5V input channel when combined with the
CS082/CS083 amplifier.
Data
sheet - Type K thermocouple |
 |
Brake
disc temperature thermocouple - Rubbing thermocouple designed
specifically to monitor brake disc temperatures, the design features a
fully floating stainless steel shoe onto which a miniature type K
thermocouple is bonded.
The
spring pressure setting may be adjusted by means of the set screw and
lock nut. Grounded hot junction available on request.
Data
sheet - Brake disc thermocouple |
 |
Type
K thermocouple amplifier - This miniature device is able to convert
the signal from any type K ungrounded thermocouple into a linear 0-5v
output. Only a simple 2-point line calibration is then necessary within
the logging system for an output in deg C.
Low
current consumption means that multiple devices may be powered by the
same Vref supply.
Data
sheet - Themocouple amplifer |
 |
